Recent content by AndySBD

Thanks for that. I'll check that out.

I've got 240v at the switch. I swapped the switch wires just in case it was a faulty switch, but it wasn't. It looks like a break is the most likely. There's not an awful lot to go wrong. It's a tiny house with 5 lights in all. I'll have to find a way of pulling the cable out whilst being able...

Hi, Thanks for your reply. I've used both a mains tester and a multimeter. Initially just a tester to see if there was anything there, then a multimeter. There isn't a junction box between the fitting and the switch, I can follow the leads in the loft where they come in and out of the ceiling.

Hi, I've got two lights on a 2 gang switch. One of which works fine, the other doesn't work at all. It seems the switch is working correctly - power into one side, which it bridged to the other, and both switch lives are actually live when switched on. In the dodgy fitting, I have 3 wires - 2...

Thanks for your reply. I don't really know how this model detects water level. The tank just has a plastic doofer in the hole that goes up and down with the water I assume. This possibly makes contact with something inside the dryer when the tankis full, but I can't find anything. It's a bit of...

Hi, I have a Zanussi ZDC8202P Lindo 300 Condenser Tumble Dryer that turns on OK, but when you press the 'Pause/Start' button, the machine beeps 3 times and the 'Pause/Start' light flashes red. It has done this previously, and after a good clean, has worked again. This time, however, that is not...