Recent content by angry1

ye-but be careful about the cut out dimensions

built in ovens normally have the controls at the side so if you use it as a built under oven the controls will be too low -under ovens have controls at the top

there should be no pipes behind an intigrated dishwasher -only horizontal ones at floor level

sorry

HI-JUST REPLACED BEARINGS,NOW CONTROLS WONT ROTATE,JUST KEEP CLICKING-ANY IDEAS GUYS? :x _____________________________ Lynda, moderator pleasse turn caps lock off

hi-remove lid,undo 2 screws holdingback panel,at bottom of machine there is 2 white bungs.remove these and there are 2 screws underneath, remove these and the rear half of the casing comes off

just remove hose connections at back and ondo 4 screws on top of the frame?

help! bearing gone,is replacing a diy job?

apart from woburn fixings,does anyone know a good saw sharpening service in or near milton keynes?

use a smal offcut of board/fit it into the tongue/groove and off you go

must get my eyes checked----cant see a thing

for a signing up fee of 200 they put you on thier web site and advertise your company-and gaurantee at least 5 enquiries a week.i spoke to 3 people on the site and they said they paid up and never heard any more from them. this rep is like something from readers digest---cant get rid of him.

anybody had dealings with a company called ufindus

brent plastics in willesden 02084510100

try brent plastics on 08004510100