Recent content by AntonyE

Thanks. I did find some similar issues, but no solutions unfortunately (I've tried the zone valve and it's not that).

Hi, I have two indirect water cylinders (Gledhill) connected to a gas boiler (Vaillant). The system is setup/programmed so that the tanks heat up twice a day for about 2 hours. When the tanks start to heat, one of them makes a loud vibrating noise, sometimes for about 15-20 mins, sometimes for...

Thanks again tell80 for all the clear advice in #3 and #7. I believe the floor is solid. And thanks Blup as well. Just to check regarding the comments on the plinth ... you're saying that the rendering on the plinth should be removed since it's probably allowing damp to bridge from under the...

Thanks Koolpc. So my plan is to get someone to remove the decking, reseal the wall from the outside, improve the drainage as needed, and then put new decking in that's probably about 20cm lower. Does that sound like a reasonable plan? Appreciate the help!

Thanks for the responses! I've attached a few pictures showing the overall internal room structure (the damp is to the right of the double door), the threshold (the decking is actually ABOVE the level of the floor), the outside of the wall that is damp, and a close-up looking down the gap...

Hi, I'm trying to identify what is causing these marks on my skirting board (see picture below) and would appreciate any advice! -- The skirting boards were changed about 6 months ago. There were no marks on the skirting board then. I don't know if the door frame on the left was buckling. --...