Recent content by ArthurD

Sorry to confuse you, my neighbours alarm that I am having the issues with IS the Premier Elite 24, my alarm is the old one - it works great. I can now set the alarm and unset it. Once again thank you for your support.

Right my problem is that I assumed that I could only have unique address numbers. We are now cooking with Gas. Thank you for you patience I have a reasonable knowledge but at the age of 79 and only doing this to help out a neighbour I get the odd thing wrong. Once again thank you very much for...

That is how I had them set initially, however I started with 2 because the remote expander is set to 1 is my logic wrong, can the expander have the same address as the first keypad

I'm Going to put the address setting back to where they were and start again. One question, Should these keypads be assigned to a zone?

Nope, it looks like the addresses were correct the system is not happy now.

I think that may be the issue, I've got the dip switches the wrong way round. I'll change the keypads now.

I set the address to 5 and the system doesn't like it keeps asking me to confim the devices it shows the key pad as X. I thought that i had set the addressed correctly i.e. Expander address 1, key pads 2, 3 and 4. It seems that the keypads can only have 1 to 4. Can the expander and a keypad...

I set the address to 5 and the system doesn't like it keeps asking me to confim the devices it shows the key pad as X. I thought that i had set the addressed correctly i.e. Expander address 1, key pads 2, 3 and 4. It seems that the keypads can only have 1 to 4. Can the expander and a keypad...

There are only three keypads in use, I'll change the address to 4 and try again.

yes

The system is new put in the begining of this month, it's my next door neighbours. Wintex version is 7.2 System version My own alarm system is a Texecom Premier 816 whish is about 19 years old and it was so easy to set up. It seems that the latest version Premier elite 24 is so much more...

Today I performed a walk test - all ok, Zone test - All ok Tried to arm the system with two users nothing happened - no exit tones nor being set. I have used Wintex V7.2 to save the log which I list todays activity here. I have also attached a file with screen dumps that may also assist in...

Area A arming mode is set to Entry/Exit as is the arming suite A. All three remote keypads are set to Area A only. All users, other than Engineer and master, are set to Area A only and have attributes Allow - Arming, Disarming, Omitting, Disarm First, Report open/close, User Config set to Allow...

I have installed a Texecom Elite 24 alarm wired system and a walk test shows everything is working, A system check also verifies that there are no problems. However, when I enter a user code the system asks do I want to set the alarm and I say Yes by pressing the yes button there are no exit...