Recent content by AsleepInYorkshire

I've got to congratulate you on some great tenacity. You've done well to question the "expert" damp proofing companies. 10/10 I'd like, if I may to augment JohnD's earlier please. If there is a damp proof course, as John has said it will be slate. It's rare but they can fail. If the slates were...

When reviewing costs for foundations in cost order I have a rough guide I've always used Deep fill concrete trench fill (up to 2m deep) with precast concrete beams Raft Piles I work in volume housing (commercial) so my guide may not apply to a small build. However, I can't imagine on an...

Hi Matthew, Bear with me please. I can't recall the exact figures but roughly speaking 90% of the light that comes through a window comes from the top 15% of the window. The rest of the window is there for us to see through and provide a window cill where the cat can sit. There will be two...

You can treat the existing joists by applying woodworm treatment and replacing any rotten areas. AiY

Hi Gizzydash, I'm not sure what you're trying to achieve. Do you want insulate the floor? My advice is you should. However, I don't agree that "quilt insulation is your best option because someone has said it's as cheap as chips. It's one option and it is cheap. It is not as thermally efficient...

Alternatively be patient and wait for the builder to do the job for you? Just a mindless thought. About 40 years ago I was proud (then) to own a Marina - it went well in a straight line. It needed some work doing on it. I asked the garage how much they would charge for the works. They quoted...

Redland Mini Stonewold Flat Concrete Pair of Half Slate Tiles - Black | Roofing Superstore® AiY

Found it. No, sorry there's not a tile and a half - talking out of my rear :-) AiY

Can I check it's a Redland 90 please? Thank you AiY

This photograph. The timber laths should be "staggered" so that they do not all butt up over one joist. This prevents to two nails being driven into the roof joist and effectively creating a weakness which could split. (Ignore the spacing dimension in the sketch below) Yes 5U felt is used...

The left hand wall in the lounge will be load bearing for sure. If I was designing the foundations for the house I'd make the wall that divides the dining room and lounge structural and run the foundation straight through to support the stair trimmers. But I can't say for sure. AiY

Yes. Sorry I should have said use a 225mm deep joist. It will course into the brickwork better. When you cut a treated joist or any treated timber you should treat the "raw" end with two coats of hand applied treatment. Generally speaking there are three kinds of insulation available on the...

If you remove the internal sleeper wall and replace the 110mm joist with a deeper floor joist - say 200mm then you don't need to put air bricks is. The added depth of timber joist will allow a greater depth of insulation supported by the deeper joists. I'd suggest you consider PIR which is more...

You could make a small local retaining structure around the air brick using some precast concrete path edgings. Come away from the existing wall on two sides at 90 degrees by 100mm and join the to ends up. Only air will be able to pass through the brick AiY

I've some thoughts. What are your trying to achieve please? I think there's an opportunity to increase the floor insulation (various approaches available) but looking at it the floor it seems structurally sound but the odd additional cross flow air brick wouldn't go amiss. AiY