Recent content by Async

Thanks for your help, always appreciated. Will try this out later.

Ok, how should I test it with a multi-meter, its on a 2 way switch, and the last light just a neutural and a live???

I have wired them as they were, when they were on pendants??

Anyone???????

No all the other lights work fine???

Hello, I installed 5 GU-10's over the weekend. I have a slight problem though the 3 which I installed upstairs work fine and are bright. The 2 installed downstairs in the hall way work but are very dim??? By the way they are mains and not LV. Any help appreciated.

????? Anyone

Right then, I have sussed the Thermostat end where I connect the 2 lives and neutral. On the Hortsman, the document says if you connect to a Honeywell use pins 3&4, so do I put the neutral into the main 240v coming in????

Sorry mate, I know it was a bit vague. When I get home I will have a look and get the pin-out numbers etc....

Hi all, I have just installed a Honeywell Thermostat, there is a 4 core cable there, does anyone know the termination of wires for the Thermo and timer, any help appreciated.

I was thinking it might be the bulbs! I am not at home at the moment,so I cant check them. So would the bulbs be a good idea???

I bought the same dimmers (plastic) My problem is that they flicker when turned on full, is there any way of getting rid of this??? I have one either side of the bed 1 gang 2 way, and a 2way 2 gang as main controller.

Here is my dilema, I have a 2 gang 2 way switch call this (switch A), 1 controlling the ceiling light - no problem, on the second switch of the 2 gang 2 way I have 2 x 4 core cables one going to a switch one side of the bed and another switch the other side call these (switch B and C), these...