Recent content by Austin_Yeahbaby

  1. A

    Texecom Panel - Can't access UDL menu - Connect Install

    Just reset and without sending my old config I can connect to menu 7 UDL. Obviously something in the config was screwing it up.. Just connected via the app. so I know it's sort of working.. Just need to figure out which config screen was screwing it up!
  2. A

    Texecom Panel - Can't access UDL menu - Connect Install

    crap, changed com port 1 to smart com and com port 2 to COMIP and sent config. It asked to reconnect and now can't get in via cable and Wintex Probably need to reset again!!
  3. A

    Texecom Panel - Can't access UDL menu - Connect Install

    Upgraded from 3.00. I can seem to get into every engineer menu except 7. Can the connect be setup via Wintex?
  4. A

    Texecom Panel - Can't access UDL menu - Connect Install

    Thanks for the speedy reply, using fob engineer menu press 7 it shows UDL/Digi Options.. Press Yes and get beep
  5. A

    Texecom Panel - Can't access UDL menu - Connect Install

    First post...hoping this is obvious fix (but not to me!) Just upgraded a 48W panel to 4.02 and that seemed to go fine. Sent config back from Wintex as well. Connected Connect unit up on com 1/2 and set wifi password to home network etc. However I can't seem to access the UDL menu from the...
See more
Back
Top