Hold down D on the keypad, after while it should say security code, if nothing happens at all then looks like 12v issue, because just 12v on the keypad you should be getting message saying RS485 failure. Also try down power and power back up
Bottom JUMPER on the Deltabell, looks like it is set on external battery, you want that to be on internal so in a event of the panel power not working it will use the battery in the bell box. You don’t need the green cable in LED on the PIR unless you want to disable the PIR LED light
Actually there was four gates, three houses, smaller houses had one slider per house whilst bigger house which was top house had two sliding gates. They are 3-4 bed detached homes with a side gate to get to back garden. Top and bottom houses had same builder who does “electrical” work, and don’t...
I believe and can be corrected. If you have all the codes, you can changed the App password and change all the codes. If so and you have changed them all he won’t be able receiver notifications as the account details are wrong.
Happily to be corrected
Completely unrelated to weather issue...
But I installed three sliding gates in West Hampstead with the middle one being last one to install. First house I done put a wireless door bell on there house, works perfect. Installed the middle sliding gates, and intercom. Works perfect. Ten months...
I would save your money....
It doesn’t look graded, and it screams DIY alarm system,which I am not surprised by. Also for the price, you could get Enforcer or Texecom kit for the same amount. Enforcer you can add Wifi cameras and have one app with cameras and alarm.
Hope that helps
Erm it is bad idea showing what set you have set. But if you have one on the landing and one in cupboard downstairs hidden, it’s pretty unlikely joe bloggs outside would be able to tell. It’s a bit like making the bell chirp or flash when set, that tells everyone the alarm is set. I have only...
Erm Cat5, you could look at BPT IP360, have one handset inside but also linked to your phone/tablet so whoever calls you can talk to them. Only issue it will cost you.
I would personally put four cameras in and put the cameras at the corners, so each camera is covering the over camera.
I’m guessing you are going down Coax Hikvision PoC route as IP is expensive. Personally if it is just general area you want to cover then I would suggest to install fixed...