Recent content by b21playa

This is internal, there’s a room above. Render outside the bay. I put 50mm pir insulation in between the bay studs, as far as I get it it up. Will do the remainder then the room above is stripped

Thanks all for the advice. Managed to get a few hours spare this evening and counter battened. I also framed it to allow support for the edges, hopefully it’s correct.

Thanks. I have some roofing batten left over so will use that

I may have to do this providing I can get get curtains to fit What size timber can I use for counter battening? Thanks

It’s internal. Bay runs up to first floor as well

Not coving this bit and hasn’t been there since we’ve moved in. There was a pvc trim there which I removed. Does it just need noggins in between the 2 joists or also against the wall? Thanks

Hi all Had a failed lathe and plaster ceiling in the bay which I’ve removed and planning on plastering boarding. Now the issue is the joists…there are none at the edges, can the board support itself or do I need to think of a way to add timber supports? Thanks in advance, any advice appreciated

Thanks. The engineer code issue makes sense and that’s fine today, I must of entered user code a dozen times yesterday.

Hi all Following an issue yesterday with notifications which was fixed, I have now encountered a new issue… When part settings the alarm from the keypad, it sets its as Engineer even though this user doesn’t have permission to set/unset. Another thing is that using the engineer code i can get...

Can be ignored. Found the internet connection has been accidentally paused in the router settings

Hi all I have an elite64 with smartcom connected via Ethernet. Been working fine for 2years but for some reason since 1st Jan I don’t receive notifications and there is nothing showing in the calendar. Anyone help get these back working as I have no idea when users set/unset the panel or...

Unfortunately not.

Yes 10 teeth but very pointed rather than flat cogs like picture I posted. The pointed teeth fit into dimples in the bar. Pictures attached I still have the cog from the old lock, thinking about buying a new cylinder and seeing if the cam can be swapped. Anyone know if this is possible with...

I didn’t take pictures as half the lock was missing but found something similar. The center cam had a gear on it which drove the sliding bar.

I already have the euro one but it’s not a standard cylinder