Recent content by Backbedroom

Hi, our Vitodens 100 Combi was working fine until I removed a radiator whilst decorating. The radiator was off for 2 days during which time I turned the CH dial off, the DHW was still on. After re-fitting the radiator the water pressure had dropped to 0 Bar. I brought the pressure back up to...

For the record in case anyone looks this up later. It was impossible to remove the plate heat exchanger on this installation without first removing the clip and pipe arrowed in the photo. Once removed, it was clear that the primary inlet of the heat exchanger was seriously clogged up with...

Hello, I have a Viessmann 100 WB1A (maybe 15 years old) and I want to remove and clean out the plate heat exchanger. Its right at the back and I wondered if anyone knows if it can be removed simply by releasing the 2 bolts holding it in place, or does it need other stuff to be removed before it...

Thanks for this - sorted! It looks like you are supposed to lift up the front. However I found it was less brutal to just pry the drawer up off the runner at the point of attachment on each front corner (where the adjusting wheel is) as shown in the manual. Simple. Anyway, thanks again - top...

Hello, I can't see how to remove the drawers from a Nolte Concept free standing wardrobe. The runners are under the drawer with no sign of any catches or clips to enable them to come out completely. I have tried lifting the front and also tried a sharp tug forward without any luck. I could not...