Recent content by baldyb220

Thanks everyone for the help and input. I am waiting on someone getting back to me on servicing the boiler as looking back it doesn't seem to have been serviced since installation

So I completely removed the hive and connected the 2 wires together. Heating fired up after a minute or 2 and I just had to put the integral timer on constant and it worked no problem. Left heating on for over an hour no issues. Must be the hive. I'm glad it's nothing to do with the ignitor etc...

Ok so I've put both wires in one terminal. The radiator light has lit up on the boiler but initially never fired but then did and has gone off now after a few minutes.

So this is the back plate with the wires attached to the hive.

So this is the one end of the cable from where the hive is /was going to terminal 1 and 2 at the boiler PCB I've isolated everything. What should I do to connect?

Ok thanks I kind of thought this is what you meant but wanted to double check. Thanks for your help I will try this later and let u know how I get on. Thanks

Ok thanks what's the best way to link it? I don't have those u bend connector that come with boiler in the PCB

When you say link it out just turn it off and use the integral timer?

Hi yes sorry forgot to mention it's a baxi platinum 24 ERP it's around 8 years old for the manual where it was installed

It's the slt5 there's no receiver by the boiler with this one just a hub that plugs into the router. This hub hasn't been used since I moved in. I only started using the hub last week to do factory reset and pair up again, that seemed to work but it's gone again after a few days

Hi all Looking for a bit of help or point in the right direction if possible please I've been living in my house for 2 years and never had problems with heating before. Last week all of a sudden the heating is not firing up via our hive thermostat. I've checked boiler pressure etc first and not...