Recent content by Bdar492

Thanks all for the helpful advice! Having inspected the carcasses further (howdens flat pack), they are not all entirely square. Have squared two of the cabinets between my day job this weekend and hope to get the last one square and will hope to have a nice level across all three cabinets. Will...

I measured the face of each diagonally and found only the cabinet on the right is out by 2-3mm. Is that what you mean by checking square? Could fix it with shims if it wasn’t square - really don’t want to start taking the cabinet apart!

So I took the cabinets off the wall and they are all screwed together. Now what I’m finding is that the cabinets on either side are ‘bowing’ upwards. So that whilst I can get the middle cabinet level with my laser level, I’m observing that either side cannot follow the same line. I took off all...

Thanks I will try that approach. I did align them without fixing anything as a dry run and checking levelling across all 3 and it was fine until I tried I screwed the side panels flush with each other

Hi everyone, looking for a bit a help here. I have 3 base kitchen cabinets l'm installing into my kitchen. Cabinet number 1 (far left) installed first (screwed to wall), checked all level with a laser level and also checked with a manual laser level front to back. Fastened the next cabinet...