Recent content by BernardW

I am trying to find a supplier for Western Red Cedar cladding for ceilings. The last time I used a local supplier, but I can't even find a supplier now. Anyone have any contacts please.

Thank's Chris for news about the pump, I phoned Grundfos but they wanted £1,00 per minute to tell me which pump. (ROBBERS). Does the pump fit 22mm pipe and what part number do I require?

Surely someone somewhere has a solution oe am I left ttotally on my own

The tap would appear to be fine because the cold water flow is fantastic. This new tap is taller than the previous tap as well as having a smaller bore in the flexible pipe. from the bottom of the header tank to the top of the tap is approx 11". Is this enough to give a reasonable flow, I...

I didn't realise you could get high pressure taps prior to your answer, but when I installed the tap I removed the restrictor in the hot tap connector which gave the current flow of 1 Litre in 25 seconds. I still think I will have to resort to a pump, yet no one has suggested this as an...

The tank is not in the loft of my bungalow because the pitch of my roof is only 12.5 degrees so there is no room. The bottom of header tank is approx 18" above the cylinder and has 22mm pipes. I will try your back flush idea though.

Thank you for reply, but the pressure has always been low and only allows a trickle to the washing machine when warm water is required. The kitchen sink tap is a considerable way from the boiler but the washing machine is quite close. If raising the tank will not make much difference, then a...

I have recently installed a new dual tap in the kitchen of my bungalow. The previous tap had 15mm pipes soldered into the tap so the flow was acceptable, but the new tap has flexible pipes which reduce the flow. At the present time it takes 25 seconds to fill a 1 litre jug which is obviously...