Recent content by bfdyorkie

Thanks for that - I'll bear it in mind.

Jim Crow's view sounded pretty authorative and I'll follow the advice but will probably fit new valves after some research. Many thanks for the help of all posters. I'm still not sure if my picture appeared.

The new combi boiler was installed by British Gas. BTW - didmy picture show on the post? Bfd

Here's the picture, hopefully I inherited the valves with the bungalow about 10 years ago so they will be older than that.

I'll start working on a picture - not easy for a complete technophobe but I have all the equipment needed.

Hi Pete This gets confusing. I can't see any arrows on the valve body but on the T-piece to which the valve is attached. There is an arrow pointing towards the rad on the union attached to the rad and on the union attached to the pipe there is an arrow pointing towards the pipe. Next to the...

Hi I have recently replaced my CH boiler and have started using some radiators which I didn't use before. Two of the TRVs are producing vibration and juddering noise which I can temporarily stop by slightly adjusting them. However the noise returns in about 10 minutes time. They are Danfoss...

Hi Guys Having recently changed my CH boiler I am using some radiators that I didn't use before. The TRVs of 2 of the radiators vibrate and make juddering noises which I can prevent by minute adjustment of the valves. However the noise returns within about 10 minutes. The TRVs are Danfoss - I...