Recent content by bigmadandy

Still no joy with this. The LCD just says 'Acenta G3' the whole time and with the battery connected (or mains) I am unable to silence the bell box. Can anyone suggest anything I could try? I'm getting pretty p'd off with it now :/ Cheers

Power it up with battery or mains or both?

Il try again on Monday. Pressing '0123 R' doesn't seem to do anything, Il re check everything. Last thing to try is the screws int he case of the PIR's. The type I have click together, I looked at the screw on one and it didn't seem to have any effect on the tamper circuit, there is a spring as...

And this is at the LCD panel itself: I could really use some help on this, stuck for ideas and pressure is on to get it on. Cheers

OK. I changed the wiring for the bell box in the panel today. I know have this: IMG_20170210_131834 by bigmadandy posted 10 Feb 2017 at 4:21 PM This is the wiring inside the bell box: IMG_20170210_132828 by bigmadandy posted 10 Feb 2017 at 4:21 PM The manual says that on initial power up...

I'l check it out tomorrow. Cheers for the help

On the panel the SCB pins are not labelled A or T, they are both just SCB. Does this mean these connections are not polarity couscous? Cheers

Thanks

Can anyone else tell me if this looks correct, please? Especially the bell box. Cheers

So basically connect the white from the first PIR into the board and then the yellow to the next pir's white in a block, and repeat until i get to the yellow of the last PIR and connect that in the board?

Hi, Paulj48. Can you please elaborate? I understood that each PIR had its own sperate cable from it to the board. How would you wire them in series if this is the case? Cheers

Its a Honeywell Accenta G4 panel, Iv never wired an alarm before. If someone who knows about alarm systems could check it for me Id really appreciate some help. I have not powered it on yet, when the battery is connected the bell box sounds which I understand it is supposed to as the cover is...

Cheers. On the diagram it shows the tamer connection linked, this is what make me thing you needed a cable to each PIR, and then perhaps a cable linking them via the tampers? Do you just link them out at the board using little bits of cable or something? The person I'm doing it for (family...

Thanks everyone.

Quick question regarding in install on one of these panels. I have 4 PIR's, will I need 4 separate cables going from the panel to each PIR, or do I take 1 cable to the first PIR and then go from this to the next and so on? Hoping someone can clarify this for me. Thanks a lot.