Recent content by bikerboy

Would that apply to these as these are the ones i have fitted? http://www.screwfix.com/app/sfd/cat/pro.jsp?cId=100985&ts=32675&id=25911

15mm push fit ball valve type ones (all pipework and fittings are 15mm)

Yes have fitted isolation valves on the inlet side of the pump, and recently had a plumber in to carry out other work and he checked the install and confirmed it was ok, have a surrey flange fitted to the hot water cylinder supplying the hot side and a tap of the main water tank in the loft...

A friend of mine who is totally unpractical and has no diy skills at all got fed up with the creaking floor boards in their bedroom so he went out and bought a cordless drill and a box of screws!!!! and just went around and randomly screwed the floor boards down a day or so later they noticed...

Its a Salamander CT75 2.1bar

Heres one for you! i am currently refurbing my house and have had no incidents whatsoever that is until the other half's dad decided to put the loft ladder away! was just about to get in bed and saw the light in the loft on so opened the hatch (one of those push and open ones) and the bloody...

I took a plastering course at my local college it cost me £150 for 4 nights (4 hour sessions) have used it quite a lot since didn't have a clue before but have to say it has paid off, saved a packet and have got to quite a good level now.

I have recently installed a shower with a salamander 2 bar shower pump the installation is correct, but when using the shower the pump stops when the mixer tap is central i.e 50% hot 50% cold. I have fitted non-return valves on the pump outlet but this hasn't helped. any ideas?