tried the check valve, still no joy. The pump is only activating when the hot water tap is being run aswell. Running the shower itself on hot, is not setting the pump off.
If i were to run the showers without the equalization unit, how would that work?? both showers have thermostatic mixers.
The head displacement i meant was the height of the hot water system feed tank (on the third floor) and the height of the shower head. Which is about a foot (reccommended on pump as being a minimum of 100mm). So basically the flow should be detected from the height of the shower head.....If this...
Firstly sorry if this is a repeat post, have looked in the forum but cant find one.
I have recently installed two power showers into my bathroom and adjacent en suite. The installation is an unusual one and doesnt follow the normal orthodox ways.
Basically because of restrictions to pipes...