Recent content by bowerd2

Hi -Boiler began fault by slow heating of hot water which became no hot water. Heating initially ok and then no heating. No red fault light illuminating which normally does when filling required so assume pressure ok. Electrics seem ok as boiler starting and sounding as normal but no life from...

Ok in the interest of getting to the bottom if this one and keeping the moderator sweet, can I start again. This is the situation to recap - alarm was activated from PIR, pass code could not be entered to turn off so I popped fuse out then disconnected battery. On Re-powering found the panel to...

Saxo I popped the fuse out of the spur and then disconnected the battery.

Still no joy Saxo. Tried powering up mains power which illuminated but nothing displayed on the panel and key pad not active. Your suggestion on disconnecting auxiliary and bell I did not try. Is this definately the right thing to do?

On re-powering the panel, the key pad is inactive so cannot enter 1234. Which one of you guys is right? It does'nt look like there is a definitive solution to my problem. I will try Saxo's suggestion tomorrow. Speak to you then bye for now.

Nothing wrong with battery Breezer. Don't tell me this this one has beaten you?

The photo you attach is the very alarm panel I have! I do have a single green light on yes, just indicating power to the panel, but the buttons are not beeping when I press them. The panel keeps sounding off whenever the entry door is opened. As I say any views on how to reet the alarm would be...

Thanks for the reply. As far as I can make out from the installation manual it is a 9100. The I think it goes back to the late 1980's.

Can anyone tell me If there is a way of resetting my alarm. It was triggered by the livingroom PIR by the cat. The key pad has shut itself off and I cannot seem to enter any codes. Do I need enter the main panel? It is a fairly old system going back to at least 1995.