Ok sure, have ordered a gauge and will report back. I presume as it is going up one floor and has one elbow that it will lose some pressure, but the flow seems low to me. Will come back here with an answer. Thanks so far
Far
Thanks. This could give me a pressure rating internally. I see that there is a connection for washing machine with a small bore isolation valve. The cold seems to be coming from a sink circuit but behind kitchen cupboards. Would the small bore skew results? I guess I could get dynamic too by...
Thank you for the response. hmmmm - not quite sure how to measure pressure and flow outside, nor inside re pressure (obviously flow rates I can do). Do I need to cut and insert some kind of pressure sensor on the MDPE pipe?
Far
Hi Team
Firstly, I have done my best to read and get some understanding (with plumbers and across forums). I'm stuck and could use some help.
- Victorian property, was on a shared supply. 15mm feeding my maisonette (one ground below).
- New 25mm MDPE fitted with one 90degree elbow and 2 then...