Recent content by Brian glover

MY Glow worm 30cxi is leaking water from the front of the heat exchanger.This is happening when the boiler is firing up and reaching operating temperature, then it stops. I am also seeing dripping from the end of the external pressure release pipe. So at the moment I am having to re pressurise...

Glow worm 30 cxi Boiler losing pressure . After being turned off at night I am having to repressurize each morning after which it works ok. Outside the end of the copper pipe that connects to the pressure release valve inside the boiler is dripping. Also water dripping from base of boiler - so...

Thanks for the advise - checked this morning, pressure at 0. external pressure release pipe dripping, the ground beneath the external pipe outlet is showing a large wet patch. Discovered water in the boiler top section, this had gathered and seeped through the sealing grommet below the gas...

Category: Heating, Home Heating Systems Glow worm 30cxi leaking/losing pressure? Hi Glow worm 30cxi losing pressure overnight ( I turn off the central heating each night),so I have to re pressurize each morning - then seems to work ok till next morning. The end of the copper pipe leading...

Thanks for advise. Still need clarification of silicon expansion joint. There is very slight movement in the last board where it meets the concrete.Can not remove board as it runs beneath skirting board - big job to remove. :lol:

Thanks for your imput. Do I use the flexible adhesive just when tiling over where the ply and concrete floors meet ? Please clarify the use of a silicon expansion joint, do'nt quite understand how this works. Thanks :)

I will be tiling over a wooden floor using ceramic tiles. I am using 9mm ply to cover the timber floor in my hall.However there is a small corridor with adjacent utility room that both have concrete floors which will also be tiled.The concrete floor is approx 1cm lower than the timber floor what...