Recent content by Brian McHugh

I was initially thinking of replacing my exiting upstairs single channel receiver with a two channel receiver and using the water heating output of this receiver to drive a 40A solid state relay controlling the immersion heater. After the new receiver arrived, I could see no way of altering the...

Is there any way to use two 2-channel Hive receivers in the same system using the Hot Water circuit on the second receiver to control an immersion heater via a 40A relay?

Many thanks both of you - it was only after your posts that I even realised the panel had a built-in PA facility using 4/9!! It had just occured to me that it would be handy to have this available in the event of any "Problem callers" arriving unwanted at the door. I think I may pop the cover...

We have an Accenta G4 alarm system fitted with an LED remote panel installed adjacent to the front door. I was wondering if it was possible to install a Panic Button by wiring directly into the remote keypad, and if so, which terminals would need to be shorted when the button was pressed. I...

Many thanks.

Our house is fitted with a Danfoss TP9000 programmer with remote sensor TS2 which controls DHW and downstairs heating. Upstairs is controlled via a TP5000Si programmable thermostat. Both work in conjunction with a sealed hot water cylinder fitted with 3 motorised valves controlling DHW plus the...