Recent content by Brigger

Alarm Many thanks for your help, I think I will leave the problem with my son and let him decide what he wants do do.

It is not flashing at all now set or unset, previously it flashed all the time.

My son removed the strobe feeds from the panel and the strobe stopped. We presume that this means the fault is with the panel. The system is currently running with the strobe disconnected and the alarm sets with no problems or any zones or tamper lights lit. Is it safe to run the system in this...

Yes everthing fine with the battery back in the panel and running the system the strobe only started when the mains power was switched back on. The panel is an 8SP 400N Accenta mini G3 with remote keypad. When you say remove the strobe output I presume you mean the strobe + connection. I...

[ Find above pictures of bellbox, My son powered down the system and removed the battery from the panel, the strobe stopped, on reconnection the strobe remained off until the mains power was resumed. All the logs where ok and the system was fully operational apart from the strobe which was...

Alarm problems

Thanks for that will try it. Could it be possible that the bellbox battery is on its way out?

There is nothing on the keypad/logs, tamper and attack clear as is all zones. Unable to supply picture at this time. any help will be appreciated.

My son has a Accenta mini G3 alarm fitted with a remote LED keypad, the bell box type is unknown. recently the strobe light began to flash approx every 10 seconds. The alarm will set and operates in all the prescribed tests. Any one any solutions