Recent content by Brokendownboiler

"Salus Receiver" - didn't mean much to me. Assumed the thermostat would be understood as wireless. glad we got that sorted! I will replace the batteries - this seems a probable cause here - AND the best outcome possible with heating malfunction. will update the post if the issue returns with...

Hi Ian, that was the situation exactly all last week. I would turn the heating on (at the boiler) the flames would show in the thermostat with the above read out simultaneously on the boiler. but- it has started to work again. is there any cause for the boiler not to pick up the thermo...

Forgot to turn on for the pictures - apologies. Just now, it worked when turned on. :unsure:. I moved the thermo closer to the unit for a while but no other change. Previously with heating switched On (yes 100% have not just overlooked that option!!) - the heating would kick in and then stall...

Mortar sounds like a good option in terms of solid fill for the redrill, I will look into that.

the hole I need is 8mm. the wall is concrete (painted) - that appears to be it. Im not familiar with surfaces beyond basics. There may be a thin plaster there.

Hi CBW, see attached, interesting - the thermo is showing the heating as running (the flame symbol I think)

Hi, the status code is "5.31"

Hi, unfortunately its shelving, so I do need to redrill to get the correct position.

thanks all. The RI was written on the label. (see attached) seems the common consensus here is the valves may be responsible. reckon its time to call in a pro

Hi all, Drilling into a masonary wall the area crumbled. Images included. The wall plug buried within. (easily removed). The opening is now too deep also. The area is approx 2cm x 2cm. Has anyone a recommendaiton for the correct filler to use so I can refill & redrill the same spot. Also -...

hi, Hot water works fine but the heating wont start. the pressure had dropped but I repressurised- so that is ok. when I start the heating it kicks off but then stalls and stops. the info showing on the read out during this is - 1.6 bar & the "Internal Pump is Running" symbol. any advice...