Recent content by BromleyDave

:) :lol: :lol: :lol:

Wife don't know yet - out at a dog show. Surprisingly little scale. Used Oust general purpose descaler (suitable for plastics as well). As the Can is quite small, I used 1/2 packet at a time and did it twice and decanted into a dish to check the residue.

Jobs a goodun ! Totally sorted ! Great flow, great temp @ 6. My cup ( or shower !) runneth over ! I genuinely can't thank you enough and I would thoroughly recommend you. Whereabouts are you based ? :D

13 and 14 Ohms. Sounds like you may have cracked it ! Chickened out with the vinegar but sent 'er indoors out to get some Plastic Kettle Descaler. Will post back when done. Thanx again !

Now i'm puzzled. Haven't yet descaled elements but just replaced the flow regulator (as i had one anyway), reassembled and tried it. Just the same result. V good flow. It normally is comfortably hot about 6 on the dial but it is now cold. Slowly wind it up to 10, flow is minimum but temp is hot...

Wife ( she who must be obeyed ) reckons it should only be White Vinegar ?

Another good thought - we do live in a "hard water" area. Can they be de-scaled or would say a kettle descaler ruin them ?

Cheers m8 very useful info. Resistance fine , flow as it should be , imput filter clean, no burnt cabling on either TCO. Scratching my head now. Will reassemble and test over the W/end and post back. Thanx again for your imput

Hiya. Our shower is maybe 5 years old and has just started to lose its temperature. We used to run it on a 6 or 7 and it was fine (hot without being excessive and plenty of pressure). Now when I start it on a 6, the temp is tepid. If I slowly wind it up to an 8 or 9 it eventually (2-3 mins)...