Recent content by Bubbers

took part of dash away to get at heater and found that wire was not opening the heater valve to allow heat into car. wire had bent at temp knob end and bent over stopping full extension of rack thus bending the wire. ordered new one to re fit. manually opened the heater valve by hand and is now...

ok cheer mate, will change it tomo. c wat happs thanks for help

managed to get behind dash via radio etc. there is a rack and pinion type plastic fitting that looks like it opens and closes the valve , attached to the rack there is a steel wire that opens the valve after turning the knob and hence rotating the pinion. this wire is shaped like a hook at rack...

heater knob seems to be ok although does seem to be a little resistance there, do I need to remove dsah for access to cable connections or is there an easier way. Have looked at haynes manual and not much mention of heater matrix flushing. Will have a look at temp control knob tomo. Thanks for...

hi all, I have a heater problem on my 1997 mondeo. I do not get any warm air inside the car. These are my symptoms. Engine gets warm ok, temp guage goes up to about 1/4 way (which is bout normal ) although my radiater fan does not come in.(prob cause its not reaching high enough temp) I have...