Recent content by BugsyCheek

Okay, now I'm confused! (checked the valves BTW, both open) Builders finished up today, any they were checking all the rads (a couple were leaking) etc. Couldn't get the boiler to work but left the pressure a bit high in my opinion (2 bar cold). Anyway, tried to get it to fire up again...

Thanks again. So, where are the isolation valves? Are they the valves on the copper pipes going up and out the boiler at the bottom (there are 2 turn tap style valves). If the valves are off, surely even trying to put the heating on wouldn't have made any difference though? The boiler...

Thanks for your reply. The valves were presumably open, as hot water had worked 5 mins before as had run a bath. Then decided to check if radiators were ok, that's when everything stopped working. Had looked as though pressure was high at that point (2 bar), but radiators were full of air...

Hi, I've just had a bit of a refurb and all the rads were removed. Hot water worked throughout this process, however once the rads were put back on I tried the heating, only to find the rads weren't bled (note I didn'te remove and replace the radiators!). I bled all rads, and then reset...