Recent content by canusmellgas

have you tried looking at the air pressure switch tubing......may look in good condition but not holding suction and allowing pressure switch to fail...went out to one at christmas..potterton had changed pcb..gas valve and over heat stat...tubing looked in good condition but fell apart when...

is the property a bungalow..by any chance and is the new hot water tap lower than the take off in the immersion cylinder..........or is it level....how high is storage tank above immersion heater unit. :!:

any left hand corner .if your right handed.u may have to close the middle section in if you carnt stretch to the centre line..........best of luck......r u using multi finnish or thistle

as u can see unbond didnt work...............have you a suggestion...i think you will fine it works a treat over artex and the like with no shrinkage or slippadge from the substrate.............theres no substitute for experiance

i was refering to the job in hand not the skill involved...........have you ever tried to skim a ceiling panted with gloss paint.......i rest my case

you havent by any chance taken the pump off and put it back pumping the reverse way .??????its not puling air down from the f+e

set boiler timer to constant ...connect rf stat internally on pcb [see diagram]...........use new stat as you would conventional stat

with so many superb combi's and system boilers on the market it may be time to invest in a loverly new boiler...........with sebuk and high efficiancy all the rage ...best way to save on your gas bills in the long run

try using a little SBR rom your builders merchants....lot better than unibond and not water based.....add a little portland cement and leave too dry.................guarantee you it will stick like the preverbule

you havent said exactly what you intend to skim....is it a new ceiling with new plasterboard or are you going over an old ceiling.....??????

rake back all affected render...romving all lose materials....form slurry coat using SPR ..from your local builders merchants and mix this with portland cement and course grit or building sand............leave too dry..dont unibond .....form new scratch and leave to cure and then top of with...