cdbe's latest activity
-
Ccdbe replied to the thread Poor hot water system..Pressure is 2 bar at outside tap, dropped to 1.8 when kitchen tap turned on. Flow rate about 4 l/min. The pump does all the hot water...
-
-
Ccdbe replied to the thread Drilling stone.Following, I'm off to Scotland tomorrow and I've promised my brother in law an outside tap - 3 foot granite walls - I've said I'll drill...
-
Ccdbe replied to the thread How to repair the decking and supporting posts?.Unless it's the picture the roof appears to be sagging in the centre so probably needs jacking up a bit after you've reinstated the base.
-
Ccdbe replied to the thread Gas regulator for barbeque.I run my BBQ and pizza oven on a big one: For my caravan I pour it into little ones. The squeamish should probably look away now:
-
-
Ccdbe replied to the thread Trailer Build.It's a pastime of mine, looking at people's homemade creations on eBay. The worst have got to be the ones where they've bought a massive...
-
Ccdbe replied to the thread Gas regulator for barbeque.There is nothing wrong with your existing cylinder, just swap the regulator.on the BBQ.
-
Ccdbe replied to the thread Trailer Build.I think you need an IVA certificate for a self build trailer. Better buying one. If it needs modifying something older (pre 2012).
-
Ccdbe replied to the thread PIR Board Installation in Pitched Roof Loft - Concerns Over Installation.I think you'd have been better with a dwarf wall and keeping the eaves clear, and a small flat ceiling in the apex to maintain good...
-
Ccdbe replied to the thread Composite decking.That's very strange, with your builder using so much glue I can't understand why it's fallen off:
-
-
Ccdbe replied to the thread Replacing a sectional garage roof.Wrapped my roof in polythene and took to council tip for free - it's not a controlled job for a diyer. I would replace with OSB and...
-
Ccdbe replied to the thread Hello, Im new. Also taken on a project and a half..Don't hold your breath, sounds like he's employed idiots to do the planning application.
-
Ccdbe reacted to freddiemercurystwin's post in the thread Hello, Im new. Also taken on a project and a half. with
Thanks.
Well I can't be arsed to read through all that so just post some progress pics so we can slag it off compliment you. -
Ccdbe replied to the thread Back box screw.I possess a "Dremel" type tool, so would cut a slot right at the bottom of that lug, drill a clearance hole all the way through the back...
-
-
CThe canal boat enthusiasts use these near me - Middlewich, Cheshire - approx 30 miles straight line to Winter Hill. Canals, being what...
-
Ccdbe replied to the thread Best threshold strip for this.They look nice, but nearly thirty quid each and I've got 6 to do so I'll need to find something cheaper.
