I used a multimeter.
I can hear the valve move when hot water is selected.
The valve closes when the hot water cylinder is up to temp.
I replaced just the valve motor with this http://www.screwfix.com/p/drayton-synchronous-motor/28670 - I'm suspecting I might have to change the complete valve...
No water flowing out of shower.
Pump is running.
Solenoid reads 3.4K
Solenoid has power to it when shower switched on.
Just split solenoid from plastic valve assembly and found that the diaphragm has a split in it.
Can I just buy a diaphragm or am I best to go for the complete...
Hi
I have a Mira Event XS that has stopped working.
So far I have checked:
motor/pump working fine
resistance of solenoid is OK
power is getting to solenoid
water flow OK
filters clean
If I run the shower without the front cover I can see that a small amount of water if flowing...
Hi John,
The thread looks in good condition - I can't see any cracks.
The end of the washer does protrude past the base of the cistern.
Looks like you have found my problem. Many thanks.
What's best now - another washer or some silicone?
Mark
Hi John
Thanks for the reply.
I think the washer is designed to go through the hole. It is a stepped shape.
The smaller diameter part goes through the cistern hole.
Mark[/img]
Hi
Long time reader who has solved many problems by reading the forums.
However, this time I can't seem to find an answer.
I've fitted a new flush unit to a boxed in cistern in my bathroom.
I cannot for the life of me get is to stop leaking where it exits the cistern. I have had to...