If you use neat PVA then paint won't stick to the the wall once it's dry.
Use diluted emulsion paint. you'll need a couple of coats.
I've seen others use diluted PVA on new plaster though.
It's just something I don't do personally.
The shower is brand new.
It's a basic mixer, lever one. I've fitted a few of them before and they've always been good.
I did a pipe flush before fitting the unit. So I'm sure there's no debris in there.
I replaced the old one as it was scaled up, tired looking and suffering the same symptoms of...
Thanks,
I did a check earlier and I'm not losing much with the shower running.
It hardly drops on the gauge.
I've managed today to get a shower and keep the temp constant, but you can still hear the boiler kicking in and out.
I took the headset off and it still cycles on/off.
I'll look at the...
Put the gauge on it today it's showing 2.5 bar static. That's taken from the lowest outlet. Outside tap.
Not had chance to do any more tests as at work.. But managed to get hold of water company who's saying my area is only getting 2.17 bar
Hi all,
I've just moved to a new place and the boiler is a Main 24E.
A few years old I guess.
The CH works fine and the HW is piping hot downstairs with reasonable flow.
However the highest point of the water pipes is the shower where the flow seems less than enough.
The bath taps and basin taps...