Recent content by Chris-T

Yes, i think it is.. Is the diverter valve shaft difficult to replace??

1. Yes. Replacing that part sorted out the problem with the light being on all the time. That pin now moves freely. I did get hot water running no probs and left it running hot for 10 mins. Then i tried C/H 2. Ah, i see, that pin senses the pump is running. Cant get that pin to retract at...

Hi Gasguru Followed your advice and today i changed the DHW flowswitch. A local parts centre had the whole assembly and the microswitch. I reused the old screws as you suggested. However, still got the same problem. Have managed to get it running for hot water and i let it run for 10mins...

Gasguru is right. I've just had a look at the manual and can see what he means. The small brass assembly with a microswitch on. Sits just to the left of the pump.

Thanks for the advice but i think i'll get a local corgi in to do this for me :) All those things sound hard to fit Would this part also affect the heating side which is also going no-where (other than heating the frist foot on the flow) Chris

Hi Guys. Need your help with this boiler. Been Ok for past couple of months since we moved in - until now. Boiler fires up ok but then 30 secs or so later it locks out. This happens on hot water or heating. THe heating pipes stay cold. I have also noticed that the demand light for hot water...