Thanks guys
I ahve been stewing over this for months, keep putting it off, thinking it is going to worse than it is
You have given me the help I need just to get started
The carpet is up at the moment, so a a bit of black staining should be ok.
The good thing is that I can at least...
I have just found this....stupid me, I have been searching the net but not stating it is for an upstairs rad, so all info I have seen, talks about draining the whole system.
From what I can see, it is possible, just need to block the vent tube as well...
Dear all
Been looking to move an upstairs radiator to the left 2m.
I don't really want to go through having to drain the whole system and rebalance/bleed the whole lot again, so was wondering if it would be possible to block the header tank outlet in the loft to stop water re-entering the...
Great info
Many thanks
The way you have explained it makes it very simple to understand. I have been scratching my head trying to work out how to wire in the CM907
I will see how I go with the new basic stat and go from there
Regards
Chris :D
Hey ho
I have spent most of last night and this morning trying to figure the wiring out.
In hindsight, I should have used a different plumber as he stated that there was no need for any room stat.
The wiring center is full of all sorts and none labelled, ut by using the info sheets I...
Thanks John
It is a Honeywell Y Plan set up with a ST 699 programmer. I have just found the paperwork for it. The only problem I can see is that there is no room stat in the system. It seems too simple to just wire in the stat as per the instructions.
I found this on another post here...
Thanks for quick responses
It has a Honeywell Programmer. The Boiler is a Thermecon External Oil fired.
Just trying to get my head around it all because I don't want to blow the place up
Regards
Chris
Dear all
Now that the cold weather is setting in, here come the questions about CH.
I had new CH heating installed a couple of years ago and only have Thermostats on the radiators, with no room stat because my plumber said that this is normal. The problem with this setup seems to be that I...