Recent content by chrisjs

Thanks again sheer.

Got it :D Drawing the diagram obviously inspired me. For the benefit of others, here is how it can be done: 1. Find a tool with about a 1cm blade, but not a sharp one. Most screw drivers are too narrow and I would fear for your plastic - I used an old and VERY blunt chisel. 2. From...

Thanks for the quick reply sheer; at least it sounds like something humans can do. Unfortunately it's the bit you can't quite remember where I am stuck, and I normally think I am quite good at these things :oops: I wonder if this attempt at a cross section through the assembly will help...

Thanks to good advice on here http://www.diynot.com/forums/viewtopic.php?t=32670 I was able to locate the fault on my Zanussi Jetsystem 1200 washer. Have just ordered a replacement valve and am trying to get the old one out, which is where I am stuck. The valve is mounted in a larger D shaped...