Ok, I've swapped all possible parts from the identical shower in the other bathroom (the one that works fine) including the cartridge and the thing that turns the shower on and off. (See photos) Swapped the shower hose and head from the other shower, still same problem.
The parts from this...
Ok, I've tried testing the flow rate with the pump switched off and no water is running out of the faulty shower at all. The good shower ran fine, 4 litres in 2 minutes on the cold. Not sure what this means.
Thanks for that, I will test the flow rate later this evening. Both showers are at the same level, 1st floor family bathroom and en-suite. Virtually back to back. The pipes (pvc) leave the pump within the airing cupboard into the loft then T off to each shower which are within a couple of metres...
Had another go at the faulty shower this weekend. Unfortunately do not have anything to measure the flow rate. However I did strip down the shower unit. The filters were quite dirty which I cleaned. Also I de-scaled the cartridge. Still same issue when put back together. Thanks
Thanks for the reply Rob,
I've just cleared the x2 filters out from the hot & cold. Not much dirt in there, however one of them was dislodged and will need replacing as it has come away from the rubber seal. I have put it back together without the filter as a temporary measure to test it and the...
Hi,
I have a Salamander 'RIGHT RSP 75' pump that feeds x2 showers. One shower works fine with no problems at all. However the other shower began with a fault some time ago where it would not start the pump unless the shower was on full cold to start with. Now it doesn't work at all now.
I'm...