Recent content by ConcreteCow

Sorry for reviving this thread. But did you take care of the smell problem?

I’d be pretty concerned too if there was a gap like that after installing new windows. While a small gap can happen sometimes due to measuring or unexpected space behind old frames, an inch sounds like a lot. Gaps like that can definitely lead to noise and drafts if they’re not properly filled...

It sounds like you’re hoping to replace the Danfoss TPOne with your Hive Mini setup. Since the Hive receiver needs L, N, Earth, and a switched Live, you’ll likely need to identify which wires in your current setup can be repurposed for this.

But it’s fair to ask how realistic these promises are and what specific steps he plans to take to make them happen. Big changes take a lot of time and cooperation to pull off, so I’m curious about the details behind each of these promises.

Yes, they can be rotated. Not a problem, adjust for vertical and just make sure the float and valve lever is not impeded by side of cistern or any other object.

This happens from time to time. I've had a couple over the years that have done that. Looks like the later models have been redesigned to avoid this. I would get in touch with FM UK Support...

Can't even remember where the boiler was, let alone what the end result turned out to be! Nearly 4 years ago. Possibly the Fan, but otherwise, unless I remember during my sleeping hours, I can't offer any more help, sorry, Regards

Thanks for the info. To cut a long story short, called in a HE who diagnosed air in the pilot flame feed tube... eventually. This wasn't being purged in the short time the ignitor had to ignite the pilot flame, due to the very small holes of the pilot injector not letting enough air through...

Yes and Injector OK. Gas solonoids measure at about 4K each, and there is 210V DC across the solonoid which actuates when applied. Measuring right hand most pins... O O O O O n/u E ^ ^ sorry, posted ASCI art...

Boiler was out of service whilst building work completed. Boiler was recommissioned but fails to fire. :( From Mains ON and CALL for heat, Pump starts, Fan starts, Gas valve ON, Ignition sparks, but no burn, then flame failure light comes ON. Injector looks clean, spark tested with external...

Hello all. Has anyone replaced, or is it possible to replace, the 4601 actuator with any other from the Sunvic/Duoval range, which might be a cheaper option than getting a replacement 4601/5602 actuator? Regards,

Thanks for the advice. Had a look at web site. Not a lot there to be honest, certainly not what I'm looking for. Or at least no downloadable manuals or instructions for the DD210 that I could find. A bit of a warren. Thanks again, regards,

Been asked to look at a DD210. The lower immersion heater (GU 11TC) has burnt Lucar connnectors and needs replacing. Advice please on general depressuring, draining and re-com. No sign of installation and users manual at the site. regards,

The shower drain is clear, the inside of the saniflow is clean (well ish). The only thing I can see wrong is that the saniflow non-return valve on the shower side is floating about inside. I am a bit loathe to put the whole thing back togetehr when I can't see anything wrong. Nope not fixed...

I thought he was talking about fire in garage entering into kitchen via flue. Having a fire in the garage may be the more serious if there is petrol involved, especially if the garage is internal.