Recent content by crustyhead

Yeah my mistake it's thanks for correction.

Have sorted it and the system is working fine. All I did was the red and yellow together I believe this is live and switched live. Now I know this is coorect I will chocolate block the red and yellow and isolate the neutral blue. Remove the cradle and place a cover over the wires to make safe...

You will see my electrical knowledge is basic

It's the3 way pump hot water gravity heating pumped

So when the Drayton Digistat SCR is connected is that not doing anything??

This is the wiring for the receiver unit untouched the Hive unit fitted straight on without changing the back plate. I followed instructions to change to gravity feed to gravity feed green light changed to blue which is correct. Both light come on hive hub and thermostat work but heating for...

Yes with you on that but as they are. The heating is not working at all, this wiring is overriding the Hive thermostat. As soon as I reconnect the old system up without the Hive everything is ok?

It mentions bridging the thermostat out. I am not sure how I do this.

Is picture working please?

Today fitted a hive 2 which was pretty straightforward and all worked till I come to decommision of the wireless Drayton thermostat on the wall. Detatched the unit and the craddle is shown in the photo. Have left this as shown bridged this with the brown wire for the Drayton unit. Is my problem...