Recent content by cwvxr

Great, Very helpful. Thanks. Once I know the zones they are on, do you know what programming commands to use?

Aaah. This is what I need to find out.

Yes i have done that already. As you said above, I still need to make the Hall PIR as timed exit and the door swtich to not used.

Thanks. Any tips for the programming side of things? Not too ofay with programming the 9752

Thanks. Can I remove the redundant wire to the alarm control unit? I'm pretty sure I have set the level A to timed exit. Yes, there is a PIR in the hallway.

Hi, I am removing my internal porch door, which has a ten pence sized contact in the door and a contact in the door frame which has a wire going off somwhere (magnetic reed switch?). When I set level A the closing of the internal door sets the alarm after about 7 seconds or so. Can I remove...

So I haven't put the covers back on correctly?

Hi I am having problems exiting 'installer mode' on my Scantronic 9752 (9940 keypad). Basically a battery went low on two of my shock sensors (738r), so I replaced the batteries for good ones. Anyway, can't get out of installer mode (99 tick tick) now as it keeps informing me I have two tampers...

Hi First question in floorings :D I have a soild wood floor that is 20mm thick that sits on 1mm dpm and 3mm underlay. Can anyone advise on the correct ramp profile from this to carpet. Carpet is approx 13mm high. Cant seem to find an approriate oak profile. Thanks.

Thanks :D

Hi, Is the bend rad for 2.5mm T & E 29mm? Also, I am routing the above parrallel with a floor joist so i intend clipping to it, length will be approx 2 metres, is every 250mm adequate? Thanks for you replies.

[/url] Never had a trip yet. I too was suprised at the kitchen being on a 20A.

Forgot to mention. The washing machine is in the garage on another circuit. Kitchen has usually a kettle plugged in, microwave and toaster, fridge and freezer, dishwasher and oven extractor fan (obviously not used all at once) oh and under cabinet ligthing from FCU's. Only been in this house...

Sorry i understand what you mean now. Basically if the bedroom socket is the 2nd to last then I can spur from it or if it is a spur from a radial then supplying another socket i can still spur from it? EDIT - I mentioned ring as another poster said take a spur from a ring as the radial was at...