Recent content by daleb

Could it be more likely that there was something wrong with the way the old system was setup and now that it has been changed over its now working as it should? Reading online has tap temp as being between 50-60°C as standard which is where ours now currently falls.

We have a water thermometer to measure the water tap out of the taps but I dont have anything I can check the cylinder temp with. I beleive the cylinder is probably set at 60 based on the requirements for newbuilds. We didn't adjust the cyclider at all during install so cant see how this would...

The cylinder worked fine before hive and there was no interference with the wires involved when installing the Hive system so it would have to have gone faulty as a coincidence at the exact same time. Temp adjustment didn't move either. Temp at tap is as I said above 60°c. Can't tell what the...

I recently did a DIY instal of a multizone Hive system in our newbuild home. However, since the install was completed, the water out of each tap in the house is now scalding hot. Previously our water would come out at about 40°C when the tap was set to fully hot now thats just below 60°C. The...