Thanks for that Tony. It made me go and have another look. I realised that I could push the tubes further into their sockets, thus the clips sit on the outside of the step in the tube,locating them firmly, I thought it was a cr&ppy design relying on the tightness of the spring sitting on the...
I spoke to PartCentre who said I'd need to speak to Glow-Worm and I've received a reply this morning, so if you do need the O-Rings the part number is 0020027585.
Hi Tony. It isn't that high! About 1.9 bar but that beats the struggle to 1.1 there was before (made pressurising the heating circuit fun, had to do it when water demands were low). I am glad the pressure is higher but think the seal on the o rings is not particularly tight and the increase...
Over the last couple of days I've had a couple of slight spanners in the works. Thames Water have virtually doubled our water pressure (to a respectable pressure) and that coupled with the inevitable wear on the o-rings over time means that I have got wet a couple of times. To put it...