Recent content by damooooooooooh

Is the Scantronic 9651 500ma maximum?

Ok, interesting. Thanks for your help. I guess I could remove the alarm panel and reuse the AC power and mount this AC/DC Power Supply to provide a 12V amp supply to the konnected board inside the same cabinet. Would 3A be too high for the motion sensors and the typical wiring? Link to the...

Any other things that could cause this? I'm not an electrician but my understanding is if the konnected board had tried to draw more than 1amp then the AUX fuse would have blown and prevented any damage to the board?

Hi existing internal sounder was still connected to the speaker terminals which I've now removed. Also now seems that the DC Aux fail message is gone but the voltage on AUX is still in the 2-3volt range. I cant understand why the Konnected panel would need much more current that what the panel...

Hi there, I only have the keypad connected. Note, I was using this panel for nearly 1 year to power the small 12volt dc konnected alarm panel you see on the bottom of the cabinet. It is currently disconnected and not getting enough power from the AUX terminals now. All of the sensors are...

Hi Brains of the interweb. I have a Scantronic 9651, that suddenly is showing 2.3volt on the aux terminals. I've checked the battery input leads and they are reading 12v and I have also tried a brand new battery which for a small time gave 7-9volt reading on the aux terminals before dropping...