Recent content by Dandal88

  1. Dandal88

    Filler, plaster, or use something else?

    Hello, I've removed the old beading off my staircase skirting, as I plan to sand it all and paint it matte, leaving it as a square finish. Annoyingly, this was all an afterthought, AFTER we had all the walls skimmed with multifinsh. With the 10mm gap I've been with, I think most areas i think...
  2. Dandal88

    Leaking HW cylinder blown electrics...

    'Boilermate neither boils or is anyones mate' Yeah I think I'm going to upgrade. Which, by the sounds of it, won't be difficult. Thanks for your responses gents
  3. Dandal88

    Leaking HW cylinder blown electrics...

    Hello, I noticed an RCD had tripped on our dist board earlier on. Long story short, it stayed on when I reset it with the boiler switch off - I check the hot water cylinder which is where all cabling runs back to, and it was just soaked in the electrical box - water dripping off everything. Its...
  4. Dandal88

    Levelling compound

    If I can't find that information out, would priming between layers be worth doing if in doubt?
  5. Dandal88

    Levelling compound

    Hello, I've knocked a wall down between kitchen/dining room and have removed all flooring as we want to have all same flooring downstairs. See attached photos, the floors are slightly different levels, there's about a 15mm difference between the old floors at one end (see photo of the level)...
  6. Dandal88

    Concerning drainage/sewage smell

    Hello, For a while we've noticed an intermittent smell of sewage on the top floor of our house (we moved in here September 2024). It doesn't really follow much of a pattern, and we can go weeks without smelling it. However - if I ever go up into the loft, it's always smelled...
  7. Dandal88

    Aircon unit recommendation

    Hello - I was an air-conditioning installer/service engineer for 11 years (I don't do it anymore). There really isn't much between them - Daikin/Mitsi Electric were both the market leaders when I worked in the industry, and importantly you can easily get spare parts quite easily for both parts...
  8. Dandal88

    Load bearing wall....or not?

    Ah...I see...so it wouldn't be supporting joists etc? I work in M&E so my knowledge on structural stuff is quite limited
  9. Dandal88

    Load bearing wall....or not?

    Hello everyone - I recently moved into a new house and am tearing into everything DIY wise. I want to remove this wall (circled in photos). I don't think it's load bearing, but want to pick people's brains before going any further. It's a stud wall - the rest was potentially all removed in the...
Back
Top