Thanks Opps
I did specify oils as well in my email to F&B, the specific part of their response was:
As you suggested in your previous message it may be possible that oils or fatty hand acids have softened the coating, but from reviewing the images and seeing the reaction it is in my opinion...
Hi
I painted our bannister and spindles in F&B Estate Eggshell a couple of years ago. I used F&B primer and three top coats. The original bannister was varnish and I sanded this back before priming. All was fine several months.
Over time, the paint has blistered on the bannister, but only...
I've just painted Dulux Matt emulsion over F&B Estate emulsion and in some places I am getting blisters. I've let it dry and sanded back, but next coat I get more appearing, not always in the same places. It's had 4 coats so far, so if it was a reaction I thought it would have covered by now...
I have always struggled to get roofers because it is a slate roof and I feel I am often overcharged. I had one to do a chimney a few weeks back, so hopefully....
There isn't a soffit as such, if you look under the eaves you see the felt. At the moment there is just a hole through until the roofer comes. I have included a photo to show it as best as I can.
Thanks Andy, I was told that it would lack support because so much would be above the level of the guttering (I guess about 1.2m), but maybe the join in the elbow will hold it firm enough? I really don't know much about drainage sorry.
Hello
My soil vent pipe used to go through the roof and the lead had corroded - the roofer suggested an AAV and slate over the hole. I spoke with a plumber who said the same and installed a Durgo valve as per the attached photos. Problem is, we are now getting foul smells in the bathroom...
Thanks all.
The room was originally a bedroom and converted to a bathroom long before we bought it, but the vent pipe would have been put in at that point as we have an unused cast iron one around the other side of the house where the original bathroom was. Having measured today, I think I...
Hi all
My vent pipe currently goes through the roof and is held in place by lead. The lead is cracked and the vent pipe is leaning. I don't know why it was installed like this rather than as a single pipe
Does the vent pipe need to go this high or could I cut it below the eaves and put an...
Thanks for the response.
There is a stopcock just outside the property boundary which apparently serves all three houses in the terrace (according to Severn Trent Water) and we would be the first on the run. There is another stopcock in the outhouse that is much newer and is in copper pipe, so...