Recent content by dav71

Thanks. The verge / junction where flat roof meets the sloping tiles roof may need adapting. This picture shows the front looking on. Red line is roof deck coming across the front, you can see where it ends (which will have a kerb trim for the EPDM) Blue line is the upstand height. The deck...

That's interesting, I never considered that. However I think planning won't allow me to affect this so at the moment I am assuming I can't alter it

Any advice please on what the normal solution is for sealing a flat EPDM roof against a sloping gable end existing roof as per image? The flat roof will have a vertical upstand of 150mm where it meets the brick. I will then have a lead flashing chased into the brick just above this upstand...

Thanks. I will. I guess I just wanted to see what the actual solution should be because I know he is just going to say "just put the pir down and by time you've screeded it will be fine". Not sure if it it will be

Hi My builder has poured a very uneven concrete slab for our kitchen extension. 60mm differences between highest and lowest spots. I need to lay rigid pir insulation over the top of this and then a 50mm screed, followed by tiles. What are my options to level this slab out? If I put PIR...