Recent content by Dazed and Confused

I've ordered a honeywell wiring centre to tidy things up. Maybe that will help. I'll let you all know what happens....I won't get a chance until the weekend. Thanks for all your input

Is there a wiring diagram for all components that I could check against?

Hi, yes, the diverter valve has 5 wires. White, Grey, orange, blue & Earth I've also just noticed that I had a typo in the wiring centre ...there is a red also to the boiler in terminal 8 (I've updated the list)

How do I remedy that?

Hi, I'll post both pics, but the wring centre is messy at best so I've listed the connections below to hopefully help. The connections are listed from top to bottom in the photo. I.e. the top terminal in the wring centre is 1 and the bottom is 8. 1: Brown to Hive Live Brown from Live switched...

Hi, the system is set to fully pumped as standard (green light). I can change the setting to gravity fed (blue light) but as I have a pump and 3 way diverter valve, I'm assuming that fully pumped is correct. If I swap terminals 3 & 4 on the hive, the CH will operate independently, but I just...

There was no room stat installed when we moved in (We're only in the property about 5 minths)

Hi DP.....6 Honeywell was moved to 3 Hive and 7 was moved to 1 Hive

Hi, thanks for the reply. It worked prior to the swap...but now doesn't seem to kick in when just the heating is selected. If I select heating only, the valve doesn't seem to open nor the pump kick in. The water works fine independently and the heating comes on if HW is selected at the same time

Good afternoon, I had a honeywell st699 which I've just swapped out for a Hive. My issue is that the heating doesn't seem to want to work unless the hot water is scheduled for the same time?? I've used the same wiring diagram as attached. Any help would be much appreciated.