Recent content by Devondave

Many thanks Alarm for all your help, will work through what you have said and see what comes out the other side. cheers Dave

now i am confused about setting the final exit zone, if there is no button and just an led on the bottom row, but you think i wont have to set that one again?

i just meant as mine as a final exit light? is that what you meant by not having seen one of those before? Or was it a final exit button you meant?

i have on the bottom row , unset, tamper,final exit on the top row 1 to 5 with an led for each is that different to normal ts400's?

thanks for this will ask a friend or relative who is an electrician to do this. how do i programme the final exit button? after the reset? zones seem to be in the manual but not final exit?

so do I take the front panel off to do this? If so should I switch off the mains?

Hi The green unset led is on nothing else My page 13 on the manual is about Initial power up? I have 3 zones set and final exit, will these be cleared by what you suggest?

thanks but I am unsure which number I may have pressed. I have tried putting in the full code twice that doesnt reset it either?

I forgot to state the make, and wasnt sure how to edit at first

I have a Menvier TS400 I tried testing if the external alarm was working today it wasnt. The internal alarm went off but not the outside. I tried doing the bell test and stupidly omitted to press number 1 after entering my code (first 3 digits) and home. since then nothing is working properly...

I have a Menvier TS400 I tried testing if the external alarm was working today it wasnt. The internal alarm went off but not the outside. I tried doing the bell test and stupidly omitted to press number 1 after entering my code (first 3 digits) and home. since then nothing is working properly...