I have a electrician wire in a Gen 3 Nest state and the heating doesn’t work and he can’t get back for over a week.
I can’t seem to find a link from the boiler to the nest thermostats.
Can anyone give me some guidance so that I can get this boiler up and running with the nest
many thank in...
Every door will need a plane put on it to make it fit correctly, you will need to but a closing edge on it as a door should never have a gap any bigger than a pound coin on any edge
The best I can do in a house is 8 doors and ironmongery in a day, which included bathroom locks and clearing up, 8.00 - 5.00
I would not imagine a diy'er could fit this number a make a decent ob of it.
If you are a diy'er I would work on one door every 5 days in a day if you want to make a...
I am at the end of my tether with this!
I fitted a cassette fire into a existing fire place some ago and fitted it with a Fire plate so that it use the existing chimney, I then dry lined the chimney with a fire line board but after a year the board started blowing out, I therefore had to cut...
Can anyyone help please?
I have the said water softener in the house that i moved into but there are no instructions for it and i was looking to find out how to set it up as the water still seems very hard.
i have purchased a hardness kit and my water is reading 300 PPM however when i go...
i am about to install a wood burner and i am looking to install a twin wall insulated liner but as i am installing it in a bungeralow however as i am looking to build on above in two years time can i extend the liner or would i need to change the whole liner?
Thanks
can anyone suggest anything?
i have a Potterton Kingfisher MF cf80 which seems to have started popping and a little bit of banging as if the boiler is kettling (boiling). i have turned down the boiler temp but it still does it.
what could it be?
never had the problem before, the rads haven't got TRV's and the room stat seems to be working fine.
could it be something on the boiler?
the boiler is a Potterton Kinghisher MF cf80
just in case you ask the pump is working fine and i have flushed the system
about 5 years ago i fitted new dado skirting and stairs and decided to use a timber stain wax on all of it but now it's time to paint it all.
what can i do to paint it as i am concerned that the paint will not take to it.
any suggestions
i have recently been having some issues with my heating due to a sticky 3 port valve, i have now changed the valve and the heating seems to be working fine however the heating does not seem to get above 21 degrees.
i have checked the rads and none seem to have any air in them so i know thay...
Hi All
This problem that i am going to list has now been ongoing for about 2 weeks now, so to say that i am getting a hard time from er-in-dors is a bit of a understatement!!!
the problem was originally due to the three port valve i had was sticking and thus making the temp rise to about...
hi all,
last night Namesag was able to help me out in getting the boiler running again but after being awake as of 04:00 thinking CHRIST it's cold i had to get up to look at what has gone wrong.
the boiler seems to only heat theheating cicuit once the hot water circuit is also on, on the...