Recent content by Diggerless

Good idea. Guess that is a relatively simple job, once power supply has been isolated of course?

Just spotted that the Safety on the stat itself had cut in. So now Reset with the stat on the lower setting. Will keep an eye on the temps and switch off if it continues to overheat. Thanks for your input chaps. :)

Out of interest are the thermostat and heating element an all in one sealed unit necessitating draining down the Megaflo or can the thermostat be replaced separately?

Thanks Tony. I have turned down to the minimum. Interestingly I left it switched on for the last hour and when I turned on a hot tap there was no mild release of pressure. There is always a slight "spurt"when the hot water has been run down and Megaflo is reheating. Leads me to believe the...

Thanks Tony. If I turn down the thermostat to the minimum and it still overheats is it safe to leave on or should I switch to the upper always-on element?

Last night I noticed that the hot water was exceedingly hot, at least 20 degrees hotter than normal, so suspect something is wrong with the lower (timer) thermostat? There are two heating elements. The upper one is just an on/off, obviously stays off is using the thermostat-attached one, which...

Hey All, DIY noob here so be gentle! :) Please bear in mind that these bathrooms are going to be completely refurbished, starting in the next couple of months I am currently looking after a large property with several bathrooms. I discovered water dripping from light sockets below the...