Recent content by discosi

1) just had a look at it again to see what type of value. might it originally have been wired as a W plan. The 3 port valve may have been changed to mid position type but not wired correctly?

1) The 3 port mid position valve after the pump feeding the HW and rads was making me think it was Y type. 2) I may have used incorrect terminology here. HW tank fed from header tank in loft and hot water to taps low pressure suggesting gravity. Water in coil through tank is pumped.

Just bought hive active heating and hot water pack. Currently have what I believe is gravity system ‘Y’ type. Boiler, hot water tank, 3 way valve, room stat, tank stat and programmer. Instructions state ‘dual channel required for boilers with hot water tank’. Dual channel wiring diagram in...

I am looking to open up an internal stud wall between our lounge and dining room but still want to have the option to close the opening with doors. I have measured up and to achieve the largest size possible are looking to install three 579mm wide doors. The idea being single door swing to one...