Recent content by DIWHY

Thanks Guys that's made me decide to get someone in to sort it, if its not plug n play I'm snookered. Thanks again

I know the ring cam sends to moby phone and has brilliant clarity and vision but can it send to a samsung smart TV, if so how ? Thanks in advance.

CBW No actual trip MCB its still set, all led red lights on pull switch and unit stay alight the water flow just stops Ian Pull cord switch looks and feel ok I just think it very odd that the water cuts off when even just on Cold setting it runs now 5 to 10 minutes and then trips

Hi Guys , CBW I restart myself. I switch off and isolate as I'm not sure what is tripping and would be still active. Then restart from fresh. JPumps see what you mean malfunctioning electrical heat, yes I'll try showerdoc.com Thanks

Thanks Guys Hi JPumps What is overheating when its set to run on only Cold setting. My mains water is brass monkeys no chance of any heat there. Hi TPlumb Model is Triton Seville it will restart after just a few minutes. I've just had it running for 10 minutes but then cut, so annoying.

Please help me its doing my head in. Everyone just assumes HOT overheat trip out with thermo BUT NOT It trips out when set JUST just running COLD approx 5 minutes every time Tested it all afternoon running JUST COLD trying to flush (hopefully Woefully) and it still stops running approx 5 mins...

Many Thanks for Replys. I only have a basic tester so it showed current where it hardly existed. The voltage getting to the backplate connector block was actually minimal hence disappearing when the clock was plugged on. I have rewired to a new 3 amp feed and all is fine. Does anybody want a...

Thanks for the reply Jack. Sorry unfortunately novice here, 6 = live 5 = neut. You mean turn off power leading to the Danfoss unit and check the connections at the fused spur ?

Heating didn't come on for the evening session it had been on in the morning and all fine. At tea time the clock had stopped, no function , no sound. Got new clock and plugged onto wall plate block bracket (have done 15 years before and all was fine) as You'll know it should be that simple. BUT...

Weep holes, plastic/copper pipe, at the bottom, into a layer of open structured hardcore/gravel approx 1 metre spacing, fabric over ends stops them clogging. Advised to tank wall above weep hole level with plastic sheet. If youre flagging the top of this new area rather than grass then most of...

Monitor has developed pink bands approx 1" wide, running full screen vertical and some blocks horizontal a bit tartenish if you will. Whats best test to establish, if graphics card has gone or monitor has gone.

This is the pre fan style, david dickinson told me! The water is 1" below overflow outlet when cold. So to recap Are we saying, cold water level too high, so when tank below heats up, it expands and dumps a bit. N.B. It only happens on first fire up in morning

Overflow pipe spurts at first heat up. Then appears to settle. Gloworm boiler (the rollsroyce as the gas board say) No emersion heater. Have checked header and water about 1" below outlet. So all seems fine after initial heat up. Clear hot water, no noise and only started about 6...

Just a tester