DiyNutJob's latest activity
-
DDiyNutJob replied to the thread Enamel for alloy wheel?.The play wheel acts as a control for measurements. It was the earliest to be done and it held the highest pressure at the end. The shop...
-
DDiyNutJob replied to the thread Enamel for alloy wheel?.OK, in a 2 week time test, all the wheels have lost some pressure. The best performer is the play wheel. The worst performer is the...
-
DDiyNutJob replied to the thread Enamel for alloy wheel?.If you know so much about balancing and have access to the best balancing machines out there, why are you the one having vibration...
-
DDiyNutJob replied to the thread Enamel for alloy wheel?.Which post # did you explain anything on? Mottie only explains he's here to not tell me anything.
-
DDiyNutJob replied to the thread Enamel for alloy wheel?.I reckon what you experienced was a psychological phenomenon. If you so want to believe something, you start seeing/feeling it. I have...
-
-
DDiyNutJob replied to the thread Is my heat pump dryer saving me money?.Since I don't exercise, putting wet clothes on rack is same as getting a free entry to the gym.
-
DDiyNutJob replied to the thread Enamel for alloy wheel?.This should be the final spend on the project. This will be used on the play wheel for practicing non-metal-metal contact between pry...
-
-
DDiyNutJob replied to the thread Is my heat pump dryer saving me money?.My indoor 0 kW rack dryer completed drying for a machine load in 24 hours. I suspect this kind of drying will be made illegal one day...
-
DDiyNutJob replied to the thread Enamel for alloy wheel?.Where does someone need to drive to and at what speed would someone benefit from this dynamic balancing?
-
DDiyNutJob replied to the thread Enamel for alloy wheel?.Alternative to bubble balancing.
-
DDiyNutJob replied to the thread Enamel for alloy wheel?.Which engineering principle tells you to add weight to the face side of the rim even though that side is already heavier? Cars under my...
-
DDiyNutJob replied to the thread Enamel for alloy wheel?.I changed my mind. I would put weights only on the inside because the wheel is always unbalanced and fall on its face because more...
-
DDiyNutJob replied to the thread Enamel for alloy wheel?.Why would you put weights on inside and outside when you can just put them in the middle? Sounds like you just want to manufacture...
-
DDiyNutJob replied to the thread Enamel for alloy wheel?.What do you think will happen, or are you too terrified to commit to a view?
-
DDiyNutJob replied to the thread Is my heat pump dryer saving me money?.No. Cold air has low moisture content, therefore has greater capacity for carrying moisture. One consequence of that is the car AC is...
